Blue Square 1130399 Q360 In-Floor Actuator Turbine

The Blue Square 1130399 Q360 In-Floor Actuator Turbine is a replacement internal turbine used in compatible Blue Square Q360 in-floor cleaning actuator valve systems. This turbine is part of the valve drive assembly that helps the in-floor system cycle and direct water flow to the proper cleaning zones.

This replacement part is commonly used when the Q360 actuator is no longer rotating, advancing correctly, or cycling water to the in-floor cleaning heads as expected. Replacing a worn or damaged turbine can help restore proper actuator movement and improve in-floor cleaning system performance.

Product Features

• Genuine Blue Square replacement part
• Manufacturer part number: 1130399
• Q360 in-floor actuator turbine
• Used inside compatible Blue Square Q360 actuator water valve systems
• Helps drive actuator movement and valve cycling
• Common replacement part for worn or damaged Q360 valve internals
• Ideal for in-floor cleaning system service and repair

Product Details

Compatibility

• Blue Square Q360 in-floor actuator valve systems requiring turbine part number 1130399
• Compatible Q360 in-floor cleaning valve assemblies using the matching actuator turbine
• Pool in-floor cleaning systems where the original parts diagram calls for Blue Square 1130399

Common Signs This Part May Need Replacement

• Q360 valve is not cycling between cleaning zones
• In-floor cleaning heads are not popping up in the correct sequence
• Valve internals are worn, stuck, or not rotating properly
• Cleaning performance has dropped even though system pressure is normal
• Actuator valve has been opened and the turbine shows visible wear or damage

Important Notes

• This item is the actuator turbine only.
• Valve lid, O-ring, gear cassette, complete actuator valve, cleaning heads, collars, and nozzles are sold separately unless otherwise stated.
• Verify your exact Blue Square valve model and existing part number before ordering.
• If the gear cassette, O-ring, lid, or valve body is also damaged, replacing the turbine alone may not restore proper operation.
• Low flow, dirty filters, blocked lines, or incorrect system pressure can also cause poor in-floor cleaning performance.

Installation Notes

• Turn off the pool pump before opening the actuator valve.
• Relieve all system pressure before removing the valve lid.
• Inspect the lid O-ring, gear cassette, turbine, and valve internals during service.
• Clean debris, sand, scale, or broken plastic from the valve body before reassembly.
• Install the replacement turbine in the correct orientation according to the Q360 valve design.
• Use pool-safe silicone lubricant on O-rings when needed.
• Do not use petroleum-based lubricants on rubber seals.
• After reassembly, restart the system and confirm the actuator cycles through the cleaning zones properly.

Related Products

• Blue Square 1130399 Q360 In-Floor Actuator Turbine
• Blue Square 1130300 Q360 In-Floor High Speed Gear Cassette
• Blue Square 1130499 Q360 Valve Lid with O-Ring
• Blue Square 1130799 Q360 In-Floor Actuator O-Ring
• Blue Square 1130100 Q360+ 2" 6-Port Actuator Water Valve Complete
• Blue Square 11420-GR Q360 Gray Nozzle
• Blue Square 11420-WT Q360 White Performance Jet with 3 Nozzles

Maintenance Tips

• Inspect Q360 valve internals during routine in-floor system service.
• Keep the filter clean so the in-floor system receives proper flow and pressure.
• Remove debris from the valve body before reinstalling the lid.
• Replace worn O-rings whenever the actuator valve is opened for service.
• Check for cracked, worn, or stuck internal parts if the valve stops cycling.
• Maintain proper pool water chemistry to help reduce scale buildup on valve components and cleaning heads.